s5100 WIRELESS CNC PROBE
$725.00
($12.99 shipping)
The s5100 is a compact IP67 infrared wireless CNC spindle probe system for milling centers. Power is supplied to the probe by an internal 3.8v rechargable LIPO battery. The probe is supplied with a USB cable for charging.
Bore locations can be located with this tool to an accuracy of .0002" and the probe can repeat a location to .0001"
The receiver can be attached to the interior wall of your equipment. Mounting must be line of sight to the spindle probe. Wiring is a simple 3 wire connection.
Red to +5volts.
Black to ground.
White to your controls signal input(5 to 24 volt tolerant signal)
Inquire about international shipping if you need it.
This DrewTronics CNC probe is equipped as follows:
**IP67 SEALED UNIT new feature**
**RED/BLUE STATUS LED
**5 VOLT INPUT
**5-24V TOLERANT LOGIC OUTPUT**
** 6061 ANODIZED ALUMINUM BODY new feature**
** 7/8-20 MOUNTING THREAD
** 4 CONCENTRICITY SETTING SCREWS
** 1/8" RUBY BALL PROBE TIP
** 2.25" BODY DIAMETER
** 3.75" BODY GAGE LENGTH
** 1.25" STYLUS LENGTH
** STANDARD M3 X .5mm PROBE TIP THREAD
** .250" OVER TRAVEL PROTECTION DISTANCE
**5.5mm CHARGE PORT AND USB CABLE**
1/2" shank to 7/8-20 thread
$48.00
($9.99 shipping)
This is a heat treated tool steel threaded 1/2" straight shank adapter for the s5100 spindle probe